Farmall & IHC Tractors Discussion Board |
H gas head
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by sgtbull on December 28, 2006 at 19:13:07 from (65.73.245.171):
I recently rebuilt a 1940 H, and replaced the distillate head w/ a gas head. The three tubes which are pressed into the head, through which center studs pass, were all but rusted away. I purchased three new sleeves from Case/IH, at about $30 each, but they were oversize.....wasn't anyway in the world they were gonna fit...I was annoyed, and trying to get the engine together in time for a show, so I turned the sleeves down on my lathe and pressed them in....seemed like a lot of trouble and I really thought they should have fit right the first time. The part # seemed to match up w/ what the original parts book called for, but what gives? Anyone else ever experience that? Or did I somehow get the wrong sleeves?
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|