Farmall & IHC Tractors Discussion Board |
Re: Flat Belt pulleys
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Haas on December 29, 2006 at 10:19:05 from (12.65.36.212):
In Reply to: Flat Belt pulleys posted by Mark on December 28, 2006 at 08:55:51:
The C and Super C pulleys will fit the Super A. The C's have the same splined shaft for the pulley. The parts manuals shows several different sizes of pulleys for the Super A, I believe from 6 1/2 to 9 1/2 inches in diameter. However, I have never seen any but the 8 1/2 inch diameter. Also, I believe some of the pulleys for later model 200's, etc may have had an offset in the pulley hub to allow for hitch clearance. None of the H/M series pulleys will fit the Super A.
Replies:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|