Farmall & IHC Tractors Discussion Board |
Re: timing? 230? plug gap? electronic ign.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob M on January 02, 2007 at 10:44:16 from (151.190.254.108):
In Reply to: Re: timing? 230? plug gap? electronic ign. posted by John T on January 02, 2007 at 08:15:14:
Hey John T - In case you haven't already figured, I kinda enjoy "tricity" discussions too...(!) Anyway here’s how the effect of spark gap length was explained to me by an AC Delco engineer back when I worked at GM - back when HEI (electronic) ignition were just beginning to appear on cars: ---- First, the longer the spark the more of the fuel-air mixture the spark travels through. Also the arc is hottest at the middle of the arc, since quenching from the (relatively) cold plug electrode surfaces reduce the arc temperature near the electrodes. Thus a longer spark results in more consistent ignition of the mixture and therefore improved combustion. Note: We demonstrated this on a Chrysler 225 slant six (with a stock mechanical ignition) on a dyno in college. We discovered increasing the plug gap from the spec’d 0.030 to 0.045 would cause a slight but very definite (several %) decrease in specific fuel consumption. Then reducing the plug gap back to 0.030 made fuel consumption go back up. ---- Second, an electronic ignition coil might be considered essentially a “constant current” source. And the longer the plug gap, the higher the voltage required to initiate the spark arc. And the energy (heat) dissipated by the arc = current x voltage. Therefore within the design limits of the coil system, spark energy must increase with increasing arc (plug gap) distance. And the greater the spark energy, the more reliably the fuel-air mixture will be ignited. (I’m sure the above is an oversimplification – and it may be all bunk. But that’s how it was explained way back when….) ---- This being said there’s tradeoffs involved. Large plug gaps/higher spark voltage results in an increased sensitivity to problems from moisture, bad plug wire insulation, dust/dirt accumulating on spark plug porcelains, etc. Also higher voltages cause corona problems, can generate massive RFI, etc. If you are inclined feel free to email me offline - so we don't continue to bore everyone else over here!
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Winterizing Engines - To Drain or Not to Drain? - by Russ Berry. What is this strange attraction I have to equipment and machinery? How did I get this way? I came from the suburbs and own a small horse farm in rural Loudoun County, Virginia. You can call me a "weekend farmer." The local farmers do. Does it bother me? No. I am just happy to have their friendship. At least the word "farmer" is in my title. But what is the attraction? How can I explain the sensation and exhilaration I feel when I turn the key and hear the engine come to life (most
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|