Farmall & IHC Tractors Discussion Board |
Re: 1928 McCormick 10-20 throttle problems
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Kevin LA-CA on January 04, 2007 at 21:05:14 from (75.84.131.250):
In Reply to: 1028 McCormick 10-20 throttle problems posted by tractor Hank on January 04, 2007 at 17:34:41:
Does the tractor run only at rated speed? Does the control rod enter the governor tube on the left or right (from operator seat)? If this is left, then this tractor is only governed at full throttle ~1100rpm. Below this, the speed lever works like an automotive gas pedal. Very sensitive too, a slight adjustment may go from stop to full throttle (governed). I believe this should be the case for a '28 (my two are this way). The fully goverened versions enter the back of the governer housing on the right. If this is true (some were farmer modified to do this) - then steelfronts is right on - gummed up or governor with broken springs. Both cases could also have a sticky throttle plate / control rod. On right side of engine. HTH kevin
Replies:
Home
| Forums
Today's Featured Article -
Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|