|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: I need Mag help!!
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Rick on February 04, 2000 at 16:43:07 from (208.157.191.253):
In Reply to: Re: Re: I need Mag help!! posted by p on February 04, 2000 at 15:34:04:
Frist make sure you have the motor at top died center on number one cylinder on the compression stroke.Now if the mag has no visable timing marks on the gears and I have had some that didn`t,this is what you need to do.Turn the mag till the inpluse is ready to kick then stop,this should put the points at a point where they are just ready to open on the lob.Next find number one on the mag cap,mark the side of the mag with a pencil at the point where number one is .then take the top gear with the segment pointing to the number one mark on the mag,put the screws back in and put mag back on the tractor while not moving the inpluse .After all this you should be in time and the tractor should run .You may need to fine tune after you get her up and running.Use caution for if you are not in time the old girl may give you a big kick.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
