Farmall & IHC Tractors Discussion Board |
Re: 674 D International Harvester Thanks For Your
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Scotty1 on January 28, 2007 at 19:25:44 from (66.52.142.4):
In Reply to: Re: 674 D International Harvester Thanks For Your posted by DADDY E on January 28, 2007 at 18:30:09:
Hi Eldon, I pulled the Injectors out and made sure the Radiator was full and got a pressure tester that takes the place of the radiator cap and pumped the system up to about 13-15 pounds of pressure and you have to look straight down on the sleeve and inspect the big part of the sleeve but also look down in the sleeve where the injectors nozzle tip goes threw. It's very hard to see dow in that penciel hole but that's where you have to look for at least a minute or more and don't expect a gusher mine was a very slow drip. Just take your time looking in the holes for a leak afer you have put some pressure on the system. I was getting pressure in the coolant system even when in was cold and I was just cranking the engine with the rad. cap off. If this is happening to you take your injectors out one at the time and crank the engine with the cap off. you'll know when you hit the right one because the pressure in the rad. goes away when you take the one out thats leaking. Hope this helps. Scotty
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|