|
Farmall & IHC Tractors Discussion Board |
656 Axle Seal Leaking...AGAIN
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Formerly PaMike on January 31, 2007 at 14:43:05 from (4.238.175.36):
We have a 656 Utility with high hours. The one axle seal was leaking badly, so I replaced it a few months ago. The seal was fine for a while, but now it seams that when I have a round bale on the three point and am on the side of a hill the fluid just GUSHES out of the seal. The problem doesnt seem near as bad when I dont have any weight on the three point. I shimmed the bearing like the book said when I replaced the seal, but it would almost seam like I need to shim it more...Could it be since it has 10K hours on it that the inner bearing is loose,causing the axle seal to cock and leak? Ideas??
Thanks
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
