Re: 300 utility 12 volt wiring harness

Posted by TDK on February 07, 2007 at 21:11:31 from (205.188.116.133):

In Reply to: 300 utility 12 volt wiring harness posted by rambler on February 07, 2007 at 18:11:03:

Some of the 350's (& maybe 300's) with 12 volt systems had a harness with an extra wire such as yours. Wired a s follows: Red - attaches along with battery cable to large stud on solenoid. Orange - attaches to small stud on solenoid likely marked "S". The other wire color is "natural" and attaches to other small stud on solenoid. The other end of this wire would attach to coil "+" post. This allows the coil to have full 12 volts during starting, but after engine fires it would run on 6 volts. I believe these had a keyed ignition switch with a push button start switch. An operators manual usually has wiring diagrams in them and I would recommend the purchase of one. It would explain this much better than I can. Good luck!!

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]