Farmall & IHC Tractors Discussion Board |
Re: Hydraulic system heater
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on February 08, 2007 at 17:46:23 from (209.226.106.33):
In Reply to: Hydraulic system heater posted by Wayne in MN on February 08, 2007 at 11:52:34:
Wayne: Have you heard the saying, "trying to heat all outdoors" well that is just about what you would be trying to acomplish. I forget the exact transmission-rear end oil capacity of an 806 but expect it's somewhere between 15 and 20 gallons spread out 1/2 the length of the tractor. To try and warm that oil plus the castings in MN this week, you'd have to start a fire under the tractor. I can tell you what will work, but you can not have an oil or fuel leak, not even a little one. Fill about 3 cast iron fry pans with charcoal, get it glowing, place it under tractor within 6" of castings. Put up plywood wind breaks. It will warm it up, but is it worth it? Sounds as though you have moisture from condensation in that oil, drain the system, flush the system, then fill with new hytran and install new filter. Further more if you don't work the tractor hard enough to get it warmed up at any given day, you will have the same old problem this time next year. This is one of the pitfalls of big tractors doing little jobs in cold weather. This is why I always kept a skid steer and a Farmall Super A around even when I owned a 560, 656 1066, etc. If the tractor isn't working hard it's best off parked. This is exactly why you folks rebuild diesel engines at 4,000 hours when they should be lasting 15,000 hours.
Replies:
Home
| Forums
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|