|
Farmall & IHC Tractors Discussion Board |
Farmall 400 2pt to 3pt and plowing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Lance_MF_180 on February 16, 2007 at 15:22:16 from (204.214.24.105):
My uncle has a 400 Farmall. He is thinking of getting the 3pt arms that snap into the 2point system. He then wants to get a IH 710 or 720 3-16's auto reset plow. Has anyone else done this with a 400 and does that setup work properly for plowing say 25 acres per year maximum?? He used my pull type melroe auto reset 3-16's but the pull type auto resets are hard to come by in central MN. Any thoughts would be aprpeciated.
Thanks - Lance
Replies:
Home
| Forums
Today's Featured Article -
Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
