Farmall & IHC Tractors Discussion Board |
Re: F-20 PTO?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by LenRahilly on February 18, 2007 at 07:11:51 from (75.69.102.85):
In Reply to: Re: F-20 PTO? posted by LenR on February 15, 2007 at 06:35:17:
I have (VERY) vague memories of a contraption that could be bolted to the back of the F-20 to make the PTO conform to what I think became an industry standard around 1950 (?). I also believe that is why IHC put that little PTO shifter box on the back of the H and M in the last few years of their production--it extended the PTO shaft. I also have (VERY) vague memories of the new standard shaft being a bit bigger than the older PTO shafts. I had an F-20 for a little while, about 20 years ago, and it had some sort of PTO extension, with a little platform on top--probably to keep the driver's clothes away from the shaft! This is what is prompting the memories of PTO changes from long ago. Sorry if I can't be more helpful than this. Somebody out there in that enormous OLDTRACTORLAND must have one of these adaptors to sell.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|