Farmall & IHC Tractors Discussion Board |
Re: Touch Control Rebuild, 100
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hobo,NC on June 27, 2007 at 09:52:53 from (71.29.35.149):
In Reply to: Re: Touch Control Rebuild, 100 posted by mark on June 27, 2007 at 08:21:29:
This'n pulls good but also would like a lower gear. Once i got use to the speed its no problem. To answer the power question its strong. I have a late 140 head and cam along with the overbore and fire crater pistons. It'ell git'er done and pull good at low speeds neer idle while cultivating. My 100 nor 140 have to werk hard I leave the hard werk for the Fords the Fords are cheaper to fix. I have good old pond water and a good irrigation system. Its extremely dry here also.
Replies:
Home
| Forums
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|