Farmall & IHC Tractors Discussion Board |
Grill insert on a 51 H
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by PUTTER on July 07, 2007 at 06:21:06 from (75.121.189.246):
Morning fellas, I recently bought a grill insert for my H from OEM tractor parts. When I tried it on the tractor it doesn't look like it fits right. Did the original ones fit in the grill flush or where they more like a cover. I've looked at lots of Hs on the tractor photos and they look like the're a flush fit. Does anyone have any experience dealing with OEM, this is my first purchase. Should I try to trim it to fit flush or send it back. I was assuming it would be the same as an original but I have never seen one, that must have been the first thing that fell off the tractor. Thanks alot PUTTER
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|