Farmall & IHC Tractors Discussion Board |
Auction Results(Kinda)
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ron in Nebr on July 07, 2007 at 15:42:41 from (66.252.113.217):
I know people are posting often wondering "what's it worth, so I just thought I'd post what things brought at an auction I was just at....I say kinda in the title because I dont remember the specific amounts......anyways, north central Nebraska sandhills ranch estate auction. 100+ degrees out. Farmalls on the auction included one A, one Super A, two B's, and two C's and an M. The straight A had a mounted sicklebar mower, the two B's had mounted 15ft dump rakes(with pto-driven hydraulic dump) and the two C's were reversed for hay sweeps. All the A's, B's and C's were pretty complete and sitting just as they had been parked when they'd apparantly "worn out" several years ago. And when I say "worn out" they were all pretty used up...sheetmetal rough, various welds, twisted front axle on one C, etc....then add in sitting outside for many years with no exhaust covering, tires rotten, etc. Anyway, they all brought between 300-400 dollars....sold to an iron guy. The M was a little better, still had it's faded paint anyway.....but missing one front wheel/hub on it's narrow front, no carb, bad tires, no grille shell....not sure of the year but it had an iron or brass shift knob....it brought about $600...from the iron guy.....more than I wanted to spend for what was there, and I have been looking for an M. What I really went to see was a metal lathe and some WW2 Military Cletracs. The lathe wasn't all there and had one broken leg and went for $275. The cletracs were in various condition, from one pretty complete to one with no engine and a couple missing tracks....all 4 went for $450 each...again, to the scrapiron guy.....they were probably worth the money, at least the one was....but I didn't wanna try to get 'em outta there over the sandy trail roads. A running but rough D-8 cat with cable dozer brought $4700. Anyway, too dang hot out there...time to relax before going to mow hay.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|