Farmall & IHC Tractors Discussion Board |
Re: A binding question about an H. How fast?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Chuck46 on July 08, 2007 at 20:59:35 from (64.136.27.229):
In Reply to: A binding question about an H. How fast? posted by Crazy Red Power - S.E.-Wi on July 08, 2007 at 13:21:52:
Hi, I started driving my dads H on a 8 ft. McCormick Deering binder when I was 8. Third gear and third notch from wide open. In a thistle patch you had to run wide open to keep the bull wheel from sliding. If the binder stopped once you would make sure it didn't again, it was not fun to clean it out and get it going again. The first round you dump the bundle carrier every 6 bundles, then in the same spot each round after that, it made shocking much easier. Yes you need someone on the binder to adjust the cutting height,the reel height, and the reel forward or back. Just keep the heads tipping onto the canvas, if it is too low it wiil shell. If the grain is down run it low and forward, and find pickup fingers to attach to every 6th sickle gaurd. If you don't have help you will need one of the setups Hugh mentioned. Also adjust the shuttle boards on the tying head to get the string placed right on the bundle, They are much easier to handle if the string is placed right. Good luck, Chuck
Replies:
Home
| Forums
Today's Featured Article -
A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|