Farmall & IHC Tractors Discussion Board |
Radiator Woes
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Pale Rider on July 09, 2007 at 21:31:52 from (207.200.116.73):
I have had an F-20 waiting to be worked on for quite a while which I have slowly picked away at over time. One of the items I knew had to be addressed was a leaking radiator, primarily around the bottom of the core. Upon disassembly and gradual cleaning of the various pieces I discovered that some (around 10-12) of the tubes near both sides have a gradual bubbling to modest leak on the ends where they penetrate the end plates when I shoot the hose close up under fair pressure at the cooling tubes in the front or back faces. Some of them seem to be leaking through the tube, most of the rest seem to be bubbling through around where the tube meets the plate, either way it's going to leak when it goes back together if it is not remedied. In the past I have attempted to solder a leaking heater core on my Oldsmobile and found that I just couldn't adequately get a good joint and wound up making it worse by melting some of the solder from the surrounding joints. It was no big deal since the heater core was a mere $30 dollars. However that isn't going to be the case with the F-20 even were I able to find replacement core. I would gladly pay the pro's to fix it properly but a cursory search seems to idicate that most local shops are proficient at flushing radiators and simply installing new ones, not actually repairing such a situation as I have at hand. My question is; Are problems such as this addressed by a good old fashioned radiator shop and I should just keep on looking or am I kidding myself and looking for something that was never really done in the first place. I am assuming that it isn't too hard a job for someone who is proficient at it, maybe that's not the case. The next question is do leave the core out to be worked on or would one expect the have to put it all back together for a shop to figure out which tubes need attention?
Replies:
Home
| Forums
Today's Featured Article -
The Day Tractor Lovers Dream About - by Angus Crawford. The day started at five o'clock on the morning of Friday, the January 29, 1999. My father, my sister, my uncle, my cousin and myself all climbed into my uncle's Toyota van. It was six thirty in the morning and we had a long day ahead. We traveled for six and a half hours to our destination - a little country town with a population of no more then one hundred and fifty people (57 of them being children under the age of thirteen). We arrived hoping to meet up with a man we knew had over one
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|