Farmall & IHC Tractors Discussion Board |
Re: re; Wide front ends
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nat 2 on July 13, 2007 at 05:10:30 from (64.80.108.52):
In Reply to: Re: re; Wide front ends posted by David Goode on July 12, 2007 at 19:32:36:
If the wide front axle was solidly mounted, I'd agree with you. However, the front end is allowed to pivot on a pin in the center, so it is actually LESS stable than a narrow front. By the time the front bolster of the tractor comes in contact with the axle tube, the tractor is already "over center" and it's too late. Both tires on the high side are already off the ground, and you either better be seat-belted in under a ROPS, or high-tailing it off the seat toward the nearest exit. The real advantages to wide fronts are the ILLUSION that they're safer, but really, they ride much better because having the tires far apart reduces the likelihood that they both hit the same bump at the same time. Wide fronts are also easier to drive because you can see the tires and which way they are pointing without having to practically get off the tractor and look.
Replies:
Home
| Forums
Today's Featured Article -
Memories of a Farmall C - by Monty Bradley. When I was a child, my grandparents lived on a farm owned by a Mr. Walters. The crops raised were cotton and soybeans, with about forty head of mixed breed cattle. Mr. Walters owned two tractors then. A Farmall 300 on gasoline and a Farmall C, that had once belonged to his father-in-law, and had been converted from gasoline to LP Gas. Many times, as a small boy, I would cross the fence behind the house my grandparents lived in and walk down the turn row to where granddaddy would be cultivati
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|