Farmall & IHC Tractors Discussion Board |
Re: Mag problems
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ScottyHOMEy on July 13, 2007 at 07:47:45 from (70.105.246.111):
In Reply to: Mag problems posted by HENRY E NC on July 13, 2007 at 06:24:02:
Henry, I left a not just a minute ago under uyour post from last night. I ahd the experience of losing all spark when I changed out points an condensor. I agree with others, that coil isn't going to die that fast, and is probably fine. Before youo chasing down and paying for a new coil, check to make sure your new poiunts are closing properly. I set the gap on mine with the mag on the tractor, and never turned the engine before I closed it up to see that they were closing. And that was the problem. The arm was binding on the hinge post, the one that I cleaned and then greased. But it was the breaker arm sticking open. A little reaming, resetting of the gap, and retiming of the spark, and that might be all you neeed.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|