Re: timing a H

Posted by stevex on July 14, 2007 at 14:30:39 from (65.77.69.174):

In Reply to: Re: timing a H posted by stevex on July 14, 2007 at 14:12:23:

The problem is the magneto is out of time with the engine. My fault, but it is out of time.

I put a piece of tissue in the #1 plug hole, then cranked till it blew out. The notch was at a right angle (90 degrees) to the top of the pulley.

I continued to crank until the notch was at the marker alongside the top of the pulley.

I lined up the rotor in the #1 firing position, or as close as I could get eyeing it.

put the cap back on and tried to start it.

Thats is were I am now. I have repeated the procedure several times with no change.

What am I doing wrong or what am I missing.

Replies:

• Re: timing a H El Toro 16:04:29 07/14/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]