Farmall & IHC Tractors Discussion Board |
Re: metric bearings?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by FLOPGUNS on July 15, 2007 at 16:38:12 from (207.144.151.12):
In Reply to: metric bearings? posted by Chris Heinzle on July 15, 2007 at 11:06:49:
HELLO JUST WANTED TO ADD MY TWO CENTS. ARE OTHER OLD TRACTORS METRIC TO? OR DID THEY JUST WANT TO HAVE SOMETING DIFFERENT SO THAT YOU WOULD HAVE TO GO BACK TO THE DEALER TO GET PARTS
Replies:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|