Farmall & IHC Tractors Discussion Board |
Re: 3- SC questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Owen Aaland on July 23, 2007 at 22:50:42 from (65.165.246.55):
In Reply to: Re: 3- SC questions posted by Dave_Id on July 23, 2007 at 18:39:37:
If you clean the bolts and clamps and oil everything up good you will find that you will not have nearly as many problems with loose wheels as when you try to do every thing dry. I have lost count of how many people have come asking how to get there wheels tight enough to stay where they want them. I have not had a single one come back to tell me that they came loose after they lubricated them. With the lube you will get them much tighter than if assembled dry. They will also come loose when you want to move them. This is really important for the larger tractors with wedge lock wheels.
Replies:
Home
| Forums
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|