Re: Farmall B switch

Posted by Idaho Ron on July 25, 2007 at 20:44:36 from (208.98.154.197):

In Reply to: Farmall B switch posted by Dave H (MI) on July 25, 2007 at 16:11:07:

I had much the same problems with my SC. I got a drawing of the wiring diagram. I tested every connection with a OHM meter. I was not getting full strength. I took off every connection and wire brushed them. Finally I could turn on the ign, switch and I could get a reading from the alternator connection to the coil. I tried the starter with a good 12v battery and it would just hardly turn over. I took the starter off and took it apart. I used electronic cleaner and a wire brush to clean it like new. I put new grease on the threads that the gear ride on and put it together. It fired the tractor right up. I cleaned the starter on the Model A and sure enough IT will start with the starter too. That starter has not worked in 20 years. Ron

Replies:

• Re: Farmall B switch Owen Aaland 21:26:08 07/25/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]