Re: H Bolster repair

Posted by Bob M on July 31, 2007 at 08:04:23 from (151.190.254.108):

In Reply to: H Bolster repair posted by First Timer on July 31, 2007 at 07:35:39:

Brady - Unfortunately have no clue what the pivot shaft surface bearing OD's are supposed to be.

However I might suggest this: Install both new bushing shells into their bores in the stationary bolster casting. Then take ID measurements of the bushings as installed. Finally direct the machinist turn the pivot shaft bearing surface OD's 5 - 10 thousands LESS than the measured bushing ID's.

This way you should end up with nicely matched pivot shaft/bushings and thus a wobble-free front end.

Replies:

• Re: H Bolster repair SDE 13:58:57 07/31/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]