|
Farmall & IHC Tractors Discussion Board |
Working on the M....hydraulic pump.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Patrick Martin on August 09, 2007 at 22:32:05 from (64.154.26.250):
So is it really necessary to fab up the two "T" removal tools that the I&T manual says is needed or is it cool to just lower it with a jack? Is it even that heavy?????? I'm gonna get cracking on these two babies soon. I've started on the newer one, the one that has the corn harvester serial number, and begun tearing down the engine and getting parts ready. The transmission actually looks nice inside and I doubt I'll do much other than just prop the back end up, fill it with diesel and let it spin to clean it then change all of the seals and such. Anything I need to look out for? I'll be contacting your friend soon Georgeky, thanks! :) I will let him know you referred me!
Replies:
Home
| Forums
Today's Featured Article -
The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
