Re: I-4 Hitch

Posted by Wardner on August 11, 2007 at 06:34:10 from (4.154.246.143):

In Reply to: Re: I-4 Hitch posted by Harold H on August 11, 2007 at 04:31:44:

Center to center on the axle housing threaded bolt holes is 28".

Length of 1" x 2" flatbar is 24".

Because both tractors use the same 9004D casting, the I-9 lower struts (1"x 2" flatbar) could be shortened and redrilled. That assumes the forward ends with the welded on pipe sections are the same. I think the ID on the pipe is 1". OD is probably 2". They would come from the same stock as was used on a standard U-shaped drawbar.

Replies:

• Re: I-4 Hitch Harold H 11:44:37 08/11/07 (1)
  • Re: I-4 Hitch Wardner 14:00:43 08/11/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]