Farmall & IHC Tractors Discussion Board |
Re: Super M amp gauge dance
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Paul Shuler on August 13, 2007 at 20:28:03 from (170.29.248.3):
In Reply to: Super M amp gauge dance posted by George T. on August 13, 2007 at 19:22:29:
I am so glad you asked that. I was sitting down to write the same thing. My H has never charged since I've owned it. After much work and help from John T and Bob M and two trips to Accurate electric { the folks that rebuild the genny} it now charges as of Saturday. Mowed for 4 hours in 100 degree weather just to watch my amp meter work for the first time. I wouldn't say mine dances but as I add speed it does shake some. When I watched close it would shake between like one and three amps but never shake more than that. My cub and Super C don't do this shaking at all. My genny and regulator are all new and most of my wires are all new, The amp gauge itself is as old as the tractor I suspect. How do you check for a good ground at the amp box?
Replies:
Home
| Forums
Today's Featured Article -
Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|