Posted by Dave S. on September 23, 2007 at 06:14:34 from (204.96.147.210):
In Reply to: 43 Farmall H LiftAll posted by Wisconsin_Joe on September 22, 2007 at 21:42:06:
If all you need to do is change the seal there is no need for more dissambley. Use a piece of 1/8" thick X 3/4" wide and 6"long piece of steel with a square end and insert it through the oil intake into the pump gears to hold the shaft from turning. Use a piece of steel bar stock that fits the slot or a hammer and brass rod and unscrew the coupler CCW (normal threads) from the shaft. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
