A lot of good advice. I did my shed at home and I put the steel reinforcing mesh in it, not that expensive and it does a good job. The day after the pour I sawcut a groove down the middle each way and then every 8'. I cut the groove about 2" deep with a masonary blade, you can rent a machine to sawcut concrete floors. This will give the floor a fracture line so if the frost does heave it the fracture follows the sawcuts..and in fact by the next spring when I dug down outside the building you could see a crack down through exactly where the sawcuts were. If you live in a climate where the ground doesn't freeze solid it isn't necessary, but where I live all concrete gets sawcut...driveways sidewalks building floors...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
