Posted by CNKS on November 05, 2007 at 18:14:07 from (216.144.104.128):
In Reply to: Re: paint confusion posted by Mike CA on November 05, 2007 at 09:56:39:
I use PPG, have never used DuPont. But they are likely equivalent and a matter of personal preference to those who have used both. The description you gave for what you want leads to base coat-clear coat, the same system that is used on new cars. BUT, in your situation, meaning a garage and limited space, you should use either Case-IH 2150 or unhardened acrylic enamel. The best gloss occurs with hardened paint. The hardener contains isocyanates, which are the nastiest chemicals you can breathe, considering health effects. You should/MUST use a supplied air system, not a charcoal mask to protect your lungs, as you can get sick with only one exposure to them (almost happened to me. Also, your neighbors, if close, are likely to complain about the smell. Iso's themselves have no odor, but if they check around and find out what iso's are, you could be in trouble. I use hardener, but I have the proper protective equipment and no close neighbors. All that aside, it is not the brand, but the type of paint. Types from worst to best are alkyd enamel (TSC, etc), acrylic modified alkyd enamel (Case-IH), unhardened acrylic enamel, hardened acrylic enamel, acrylic urethane single stage, acrylic urethane base coat-clear coat. The urethanes will not cure without hardener. Your experience and technique are going to have more effect than the type of paint you use. There are many people on the paint and body work forum on this site that can answer your questions. Also, CA has many more restrictions on what body shops can use (don't know about hobbiests) than any other state, you might check and see what the rules in CA are.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
