Posted by Nat 2 on December 11, 2007 at 15:30:07 from (64.80.108.52):
In Reply to: TA trouble posted by Southern4020 on December 11, 2007 at 14:33:03:
Better stop driving that tractor until you get the TA adjusted right. RPMs should not go LOWER! RPMs should stay the same if you're not pulling anything, or go HIGHER if you are pulling a load.
Something is binding. I would guess that it's both in TA and Direct at the same time, but the clutch is slipping enough that you haven't broken the TA, yet.
There is a very strict set of adjustments you have to go through on both the TA and clutch linkages at the same time. Screw either one up just a little, and you're asking for trouble. Tractor Vet can do it in his sleep, and rattles off the process like an auctioneer. Hopefully he'll be along soon.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
