Posted by Steven f/AZ on January 02, 2008 at 06:12:30 from (216.67.213.217):
In Reply to: 656 posted by Farmallgray on January 01, 2008 at 20:23:19:
Hugh MacKay said: (quoted from post at 04:04:08 01/02/08)I'm not sure 560 rear ends were completely IH fault. Farmars back then believed there was no limit to the weight that could be put on a single wheel for traction. The tractor rear end was a small part of the cost. The soil compaction they created was far greater, and today the boneheads want to blame soil compaction on the moldboard plow.
I've yet to find ANYONE that owned a 560 or 660 that had a rearend failure! And there were TONS of those tractors in my home area in the SW corner of ND. These farmers put the wide tires out back and weighted them down to pull, too. I even sold 660 serial #502 and it did not have the triangle stamped on the tag for updates, never been apart and was on its second engine. I'd really, really like to hear from someone who actually had a rearend failure on a 560 or 660 when they came out...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
