Posted by KJFarms on January 16, 2008 at 05:39:28 from (143.79.13.6):
In Reply to: Small pond building posted by Cmore on January 15, 2008 at 13:25:12:
I had one dug this past summer approx 120' x 200' x 5' deep. It was on a gradual slop off the pasture so only one end had to have a berm around. It took the guy with a D8 dozer 4hrs with leveling the berm to finish. We've had 14" of rain since mid Oct and is holding well so far. The cost was 500.00, sure beat me having to rent a dozer or tearing up my equipment.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
