Posted by GordoSD on February 16, 2008 at 17:54:11 from (66.115.200.140):
In Reply to: Pre Oil Rebuilt H? posted by GordoSD on February 16, 2008 at 17:16:20:
Thanks guys. I have almost every tool known to man, except one of those thumb oil cans. Lucky I have a "farmer" neighbor that would call that the most modern tool in his shop! He's pretty much a crescent wrench and ball peen hammer guy. Poor man inherited 720 acre farm from his father, 20 years ago,and is now down to 320 acres after losing the balance to the bank. Doing the math at 2000 per acre he has lost roughly 800K, or 40k per year. Has about a 100 bred cow operation and carries the calves down to the basement of his house to warm them up! Averages about 15% open cows. BTW he uses all green, two bangers! Oh Yeah, Allen, he plows his row crop fields every year! Very happy when he gets 80 bu corn. Go figure? I get sick when I go over there for any reason. Gordo
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.