Posted by Curt Cooke on February 19, 2008 at 11:00:02 from (12.150.39.226):
In Reply to: WHERE DOES IT GO??? posted by JFAVOR on February 19, 2008 at 07:37:21:
J, good luck with that H. It sounds like this thread is taking on a somewhat comical note so I'll add a couple. One of my favorite screw drivers in my tool box I didn't buy, I fished it from the bottom of the fuel tank of one of my MM's. One time, at the conclusion of a complete overhaul of the rear end of MM 705, I put all my tools away and discovered that I was missing a side cutter. I dissembled the tractor far enough to expose the transmission and rear end, drained the new gear oil out and searched. It wasn't in there but I was going to make rear sure. I found it sometime later hiding in some harmless place.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.