Posted by Steven f/AZ on March 24, 2008 at 07:09:09 from (216.67.213.217):
In Reply to: cold start DT-436 posted by nates90 on March 24, 2008 at 06:32:52:
Our 1086 (DT414) will start down to about 30 degrees without any assist. Down to about 10 it will go with a sniff of ether. Any lower than that and it needs to be plugged in.
The 1460 combine (DT436) won't start below 40 degrees without ether. Usually takes a sniff to get it going after it has sat for a month, too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
