Posted by Tom Fleming on May 01, 2008 at 18:06:58 from (209.195.155.84):
In Reply to: distillate manifold h posted by poorfarmall on April 30, 2008 at 18:04:26:
Patience, heat, WD40 (or penetrating oil of your choice). Brass drift and a ballpien hammer.
Chipped all the scale out of it with a small cold chisel. shot it every day for a week with WD-40 after heating it. At the end of the week, I started to tap the flapper with the drift and hammer. very moderate taps all along the flapper where it was against the manifold body.
It is now free, and no damage to the manifold. I only need to hot-tank it now to clean out the inside, and install it.
I also had to drill out a couple of the studs, and retap them. Not a crisis, and I ended up with a darn nice manifold to install my heat shield on.......
looking forward to running a tank of kero through it just for giggles.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.