Posted by hvacpro85 on May 04, 2008 at 17:09:12 from (69.23.134.51):
In Reply to: H with no power posted by hvacpro85 on May 04, 2008 at 07:25:16:
I think the plow is a 16" and as far as depth goes im about 10" in the ground. I tried messing with the adjustment screws on the carb today and I got no audible engine noise difference , Im talking ALL the way out and ALL the way in. I also noticed the tractor will stall out in road gear (5th). Its like when there is a load on the tractor the rpms go way down until it dies if I push in the clutch and wait a sec. she jumps right back up until the load is applied again. Someone mentioned adjusting the plow?? Just what kind of adjustments are we talking about here?? And thanks for the quick responses guys!!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
