Don't have the info at hand, but may "somewhere" in some of my old IHC brochures. Belt-driven machines required a certain "belt speed" (feet-per-minute) to run properly, not overspeed, etc. I know it was possible to get different sized pulleys for the machines (threshers, ensilage choppers/blowers, etc.). I do happen to have an H/M brochure handy. The pulley listed for the M is 11 X 7-1/2". The belt speed is 2588 feet-per-minute at 899 rpm (1450 engine rpm). There is no mention of other pulley sizes, but it may have been possible to get another size by special order.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.