Posted by garytomaszewski on May 30, 2008 at 19:12:15 from (4.158.174.185):
In Reply to: Firing up an H posted by rnicholas on May 30, 2008 at 17:40:28:
One of the things I do; Get a lawn tractor gas tank (cheap to free), 2 gal or so and plumb to carb, stops lots of crud while tank and lines are getting cleaned. Pull valve cover,gasket will be shot anyway and check for sticky/stuck valves,your fav. penetrating oil and a rubber hammer are cheaper than broken rocker/bent push rod.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.