Posted by Scott(MO) on May 31, 2008 at 17:05:39 from (4.244.132.27):
Hello, We have a 656 Farmall that we bought last summer and I'm getting it ready for hay season. When we bought it, I noticed that it seemed like the frontend loader couldn't pick a bale as high as I thought it should have. I wondered about a weak pump, but the 3 point would pick up heavy implements OK. Well, I hooked the hyd. to the cylinder on my JD mower conditioner and it wouldn't pick it up high enough to get the bolt out of transport mode on mower. I hooked it to my Vermeer baler and it would only raise the back gate 1/2-3/4 of the way up. I don't like to think that the pump is bad , especially since the 3 point works OK, but does anyone have any other suggestions (pressure relief valve or ?)? Any help would be appreciated. Thanks in advance.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
