Posted by Hugh MacKay on June 01, 2008 at 19:00:41 from (209.226.106.172):
In Reply to: Splitting an A posted by ScottyHOMEy on June 01, 2008 at 18:27:02:
Scotty: Here is how I do it. Put a bottle jack under clutch housing, unbolt front end complete with rad, put wedges in front axle pivot, clamp vice grips on steering shaft close to steering box so shaft can't turn. Remove steering wheel, then you can grab it by the steering shaft and wheel it along like a wheelbarrow, except you have one handle and two wheels. Wheel it to a storage spot, block the front axle, I like pallets. Then just drill a hole in a board for sliding over steering shaft and nail other end of board to pallets. With weight on pallets under axle, it's almost balanced.
Then remove the engine, bolt your chanel to clutch housing, making a tongue like a trailer out of it. Hitch onto it with your B and take it to suitable parking. There is no point in you guys trying to keep that front end balanced while you bolt in the chanels to make it one piece.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
