Farmall & IHC Tractors Discussion Board |
Re: 12 volt back to 6 volt of '51 M
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Phil Auten on March 14, 2000 at 12:48:06 from (206.175.72.226):
In Reply to: 12 volt back to 6 volt of '51 M posted by John on March 14, 2000 at 12:09:37:
Jim Guarino Agri-Services agriserv@buffnet.net 13899 North Road Alden,NY 14004 716-937-6618 Contact Jim on the wiring harness. The last info I had was that they were $75 plus shipping. You might want to try your local Case-IH dealer first, I've heard that they still have the harnesses in stock and they are a little less expensive. In addition to the parts you mentioned and the harness, you will need 1 Ga. battery cables. There should be three cables, one for the ground, one from the battery to the starter switch and one from the switch to the starter. I would also recommend that you replace the starter switch. This could've been the main reason the conversion was made, as they will drop a lot of voltage after they get a little burned on the contacts. Good luck, Phil
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|