Posted by Old-F20 on September 13, 2008 at 21:17:44 from (71.7.98.117):
In Reply to: Serial number question posted by Marjorie Van Fossen on September 13, 2008 at 19:24:55:
Marjorie Van Fossen said: (quoted from post at 19:24:55 09/13/08) Hey thanks, now my hubby wanted to know what weight of oil he should put in it? He was told 80-90. Back when he drove them he was just a kid and his dad did all this stuff.
that what i run in all my stuff which is all Pre 39 IHC stuff. some i play with, and others see a good amount of work and the 80-90 is just fine. i run 30WT in the engine. the axle drops get 80-90 in them as well.
oil filters you can get from NAPA, along with the rubber o-ring for the oil canister.
i should have mentioned before that those plugs are 'check plugs' and its full when it starts to run out :lol:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
