Rich: I'm certainly not sure what you are saying. Yes, these blocks can all be bored, however I question how many have ever been done. Block number 354898 R1, R2 or R3 used in SA after serial number 310300, and all SC, 100 and 200 is already bored for for 3-1/4" sleeves. The 3" and 3-1/8" kits for that block just use thicker sleeves. No point in boring that one, there is nothing larger to fit. As for the rest, one can probably buy a 354898 block for a fraction of the cost of boring.
Block numbers 366204 R1 and 367825 R1 and R2 each have one size sleeve, that being 3-1/8". Neither of those blocks are bored as large as block number 354898 R1, R2 or R3. Block 366204 R1 was used in 130 and 230. Block 367825 R1 and R2 were used in 140 and 240.
While boring is possible, it's not very practical from a cost point of view. Used blocks are just too plentiful.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
