Posted by Dr. Bert on September 24, 2008 at 14:07:23 from (72.36.57.176):
Recently I posted about a clicking sound I noticed while driving my C. Thought it was in or near the clutch. Today I got the tractor in the shop, jacked up one wheel and went through the gears. The noise is in the transmission. In reverse the "clicking" sound is the loudest, first gear not as loud, no clicking in second gear, and the sound diminishes to a "ticking" sound in third and fourth. In the higher gears the ticking is more rapid, but is barely noticeable in fourth. My diagnosis is a bad bearing on the input shaft at the front of the transmission, and the farther back the engaged gear is, the "pressure" on the bearing decreases. Would appreciate any comments or ideas you have about what to look for. (I've already started to split the tractor.) Thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.