Posted by the tractor vet on September 30, 2008 at 04:50:46 from (99.167.208.219):
In Reply to: 400 Diesel posted by DaleSelf on September 29, 2008 at 18:49:58:
Let me add a little to this . As i have run the old I H diesels for many years in both ag and ind. Whe starting first thing in the morning allow a good warm up period at least a couple min. to get it good and warmed up on the gas side , you will know when it is warm enough as the engine RPM will start coming up on its owen . make the switch by opening the throttle a couple notches and move the switch over lever to the run side . and allow some time to warm up on the diesel side . Ya can work the snot out of them all day long BUT never Stall them HOT . If ya do and this does happen ya had best make sure that there is GAS in the starting tank to make a FAST restart as cylinder temps start to go up and this can lead to cracking of blocks and heads . When shutting down Allow more then just a couple min. for cool down i have always allowed it to idle till the temp gauge is down in the cold area . At idle a diesel will cool down not like a gas engine . On my old 450D after a day of working here plowing sometimes it would take up to 20 min. to bring the temp down to the cold mark and never shut down on gas as this starts to bring the temp back up in the combustion chambers. So after ya get it started in the morning always renenber to refill the starting tank with gas .And by the way my old 450D is still out there running at a farm about 18 miles from here .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Variable pulley for case 1530 skid loader
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
