Posted by Chris NW Ind on September 30, 2008 at 16:11:12 from (64.136.26.226):
After spending time today tuning up the W9, I got the engine running pretty sweet. When I backed her up out of the shop, and put her in 3rd gear the rear end started popping quite loudly. And I could feel it in my feet. It actually locked up the left axle briefly. If I travelled a few feet in any gear the popping went away, but as soon as I changed direction it came right back.
Visually it looked like the tire was jumping a bit, but the brake drum wasn't. Seems to me it has to be the rear axle. I guess I'll start by jacking up the wheel to check it unloaded. There is no doubt that the left axle is the problem.
Can the axle be pulled like an M---By undoing the outer bearing retainer and pulling the bull gear retaining bolt through the PTO. The cutaway I have doesn't show a inner bearing retainer.
How about separating the rear axle housing from the differential?
Can't wait to dive into this job over the weekend...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
