Janicholson, I agree the sch 80 pipe is a good idea, do not get me wrong. I bought some sch 80 2" (2 3/8" OD) pipe last week. It was only about $100 a joint (21 ft). The local steel yard only charged me $17.00 to cut some other steel into pieces. By the time Jerry buys some sch 80 pipe, cuts it in half lengthwise, buys some muffler or worm clamps, some chain, turnbuckles, ect; he could buy some quad rings and packing glands to rebuild the cylinders.
Each to their own... Rebuild the cylinders or plumb in a valve dedicated to the loader. One is inexpensive and not time comsuming, the other requires more $$$ and time. Both are better than rigging up a device that will eventually trash the cylinders.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
