Posted by ScottyHOMEy on December 25, 2008 at 16:20:28 from (71.241.202.167):
In Reply to: Re: c123 governor posted by RDJ Farms on December 25, 2008 at 13:19:14:
Go for it. That's actually a nice little project.
I get a little long-winded sometimes (well a lot of the time actually), and teddy is pretty succinct, but we've all got the same idea. Put the gear in anyway that it will fit up against the ignition drive and pull the motor around to TDC on #1 compression and see how things line up and go from there.
Best of luck, and keep us posted.
(If supper's over, there's still time to sneak out tonight and give it a try!)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.