Posted by Buzzman72 on December 26, 2008 at 14:03:21 from (74.129.220.44):
On the local Craigslist, there's a seller with a 240U that has a conventional 3-point. My experience with these tractors is limited to the one Dad had in the early 1970's...and the one Dad had was equipped with a fixed-arm, cumbersome type of 3-point that Dad said was an "industrial" 3-point hitch. It was a PITA to hitch up equipment with that industrial 3-point, and I'm sure the sight of that would've sold a LOT of IH fast hitches.
So did IH offer a conventional 3-point on the 240U, or is this an aftermarket conversion hitch?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.